Gutter Materials Calculator: Contractor Estimating Worksheet
Estimate materials before ordering
This worksheet is a planning method, not an engineered drainage design. Measure every gutter run and confirm local drainage and installation requirements before purchasing.
Step 1: Linear footage
Add the measured length of each gutter run. Include an allowance for cutoffs and setup waste appropriate to your equipment and project.
Step 2: Hangers
For a preliminary count on a straight run, divide its length in inches by the specified maximum hanger spacing in inches, round up, then add one. Recalculate at corners, ends, outlets and other locations requiring additional support. Follow the hanger manufacturer's instructions and local requirements rather than treating a generic spacing as universal.
Step 3: Fittings
- Count end caps at exposed ends.
- Count inside and outside miters at each corresponding corner.
- Count outlets and downspout drops from the drainage design.
- Measure downspout heights and count elbows, straps and offsets.
- Check sealant and fastener quantities against product coverage and package sizes.
Step 4: Verify compatibility
Keep 6-inch and 7-inch size-specific fittings separate. Confirm profile, finish and color before checkout.
Use our hanger spacing guide, size comparison and hanger selection.